Installation 33/60
RE 92701-01-B/04.2018, A10VO, A10VSO Series 31,
Bosch Rexroth AG
Do not fasten down the axial piston unit until the coupling has been correctly
installed.
6.
Fasten the axial piston unit at the installation location.
7.
Align the drive shaft of the axial piston unit and the output shaft of the drive
motor so there is no angular deviation.
8.
Make sure no excessive axial and radial forces are acting on the drive shaft.
9.
For bell housing installation, check the axial play of the clutch through the bell
window in accordance with the manufacturer's specifications.
10.
Details on the required tools and tightening torques for the mounting bolts are
available from the machine/system manufacturer.
11.
When using elastic couplings, check that the drive does not resonate after
completing the installation.
7.4.5 Installation on a gearbox
The following describes how to install the axial piston unit on a gearbox.
After installing on a gearbox, the axial piston unit is covered and is difficult to access:
▶
Before installing, make sure that the spigot diameter centers the axial piston unit
(observe tolerances) and that no excessive axial or radial forces are acting on the
drive shaft of the axial piston unit (installation length).
▶
Protect the drive shaft against frictional corrosion by providing permanent
lubrication.
▶
Fasten the axial piston unit at the installation location.
No gearing forces higher than the permissible axial and radial forces should act on
the shaft; if necessary, support the gear wheel at the gearbox output separately.
7.4.6 Installation with cardan shaft
The following describes how to connect the axial piston unit to the drive motor with
a cardan shaft.
nOTICE!
Damage to the axial piston unit and leaks at the shaft seal!
Improperly installed cardan shafts generate unbalances. This results in vibrations
and excessive forces on the drive shaft.
▶
Observe the cardan shaft manufacturer's assembly instructions.
1.
Position the axial piston unit close to the specified installation location.
Allow enough space for the cardan shaft to fit through on both sides.
2.
Place the cardan shaft on the output shaft of the drive motor.
3.
Push the axial piston unit to the cardan shaft and place the cardan shaft on the
drive shaft of the axial piston unit.
4.
Bring the axial piston unit to the installation position and fasten it. Details of the
required tools and tightening torque for the mounting bolts can be obtained from
the system manufacturer.
For attachment via gear
wheel or helical gear shaft
