34/68 Installation
Bosch Rexroth AG
, A4CSG, Series 3x, RE 92105-01-B/06.2017
The axial piston unit must not be tightened down until the coupling has been
correctly installed.
6.
Fasten the axial piston unit at the installation location.
7.
Align the drive shaft of the axial piston unit and the output shaft of the drive
motor so that there is no angular deviation.
8.
Make sure that no impermissible axial and radial forces act on the drive shaft.
9.
For bell housing installation, check the coupling axial play through the bell
window according to the manufacturer's specifications.
10.
Details on the required tools and tightening torques for the mounting bolts are
available from the machine/system manufacturer.
11.
When using flexible couplings, check that the drive is free of resonance after
completing the installation.
7.4.5 Installation on a gearbox
The following describes how to install the axial piston unit on a gearbox.
After installing on a gearbox, the axial piston unit is covered and is difficult to access:
▶
Therefore, before installing, make sure that the spigot diameter centers the axial
piston unit (observe tolerances) and that no impermissible axial or radial forces
act on the drive shaft of the axial piston unit (installation length).
▶
Protect the drive shaft against frictional corrosion by providing permanent
lubrication.
▶
Fasten the axial piston unit at the installation location.
No gearing forces higher than the permissible axial and radial forces are to act on
the shaft, if necessary the gear wheel must be supported separately at the gearbox
output.
For attachment via
gear wheel or helically-
toothed shaft
