Bosch RDH06101, Installation And Operating Instructions Manual

Page: 5 / 12

Installation instructions
5
RDH06101, RDH06111 – 6 720 888 202 (2019/07)
Table 1
3 Installation instructions
Install the continuous-flow heater as described in the
illustrated section. Observe the instructions in the text.
3.1 Installation
I. Unpacking/scope of supply
• Unpack the appliance and check for transport damage.
• Dispose of the packaging and, where applicable, the old
appliance, in an environmentally conscious manner.
Table 2
3.1.1 Preparation for installation
CAUTION:
Important!
Only use the enclosed installation set.
• Shut off water supply. The electrical connection
(connection cable) must be disconnected from the power
supply. Unscrew the fuse or switch off the circuit breaker.
• There must be a clearance of approximately 60mm on all
sides of the appliance for installation.
• Observe the technical data for the appliance.
• RDH 06101: Unscrew the screws on the housing cover and
remove the lid.
II. Wall mounting
• Secure the appliance using the installation template,
screws and wall plugs so that it is vertical and flush against
the wall:
Table 3
• RDH 06101, RDH 06111: For an exposed electrical
connection, the different methods of routing the supply line
found on the assembly template must be observed.
• RDH 06101, RDH 06111: The sleeve must fit tightly round
the connection cable. If the sleeve is damaged during
installation, the holes must be sealed water-tight.
III. Water connection
A Pressurised connection
B Depressurised connection
• Fit the jet regulator supplied.
• Check the inserted filter and sleeve in the water inlet.
• Ensure that the connection pipes are fitted to the adapter
along the axis of the pipes.
• Tighten the union nuts firmly to the adapter with an open-
jawed spanner.
The T-piece and flexible connecting hose (for pressurised
connection) are available from a specialist store.
For a depressurised connection, a depressurised fitting must
be used, e.g. fitting BZ13051 which can be obtained as
a special accessory.
IV. Electrical connection
C Flow switch
D Temperature limiter
RDH 06101, RDH 06111
The installation of non plug-in ready appliances must be
undertaken by the respective utility operator or by a qualified
specialist company, who can also assist you when you are
requesting the approval of the utility company for installation
of the appliance.
The appliances must be connected with a NYM-J3x4 (mm
2
)
mains lead. Leads with a larger cross-section must not be used.
• Connect the appliance in accordance with the connection
diagram on the strip terminal.
• Screw the housing cover back on.
• After installation, give the user the operating
instructions and explain how the appliance works.
RDH 06111 High level appliance
RDH 06101 Under counter appliances
1 Housing
2 Mounting (2 screws, 2 wall plugs)
3 Filter and sleeve (inserted in inlet)
4 Jet regulator and seal
5 Only for appliances with a permanent electrical
connection: Rubber grommet
1 Locate the appliance on the screw and press down.
2 Screw in the second screw through the mounting tab
and tighten.