en
Wireless cooking sensor
18
3.
Repeat the connection process from point 2.
Setting the boiling point
The point at which water starts to boil depends on the
height of your home above sea level. If the water is
boiling too vigorously or not vigorously enough, you
can adjust the boiling point. Proceed as follows:
Select the basic setting . Basic settings →
Height
Setting value
0 m
100 - 200 m
200 - 400 m
1
1
Basic setting
Height
Setting value
400 - 600 m
600 - 800 m
800 - 1000 m
1000 - 1200 m
1200 - 1400 m
Over 1400 m
1
Basic setting
Note:
The temperature of 3/100 ºC is sufficient to cook
efficiently but, to set more intensive cooking, a lower
level can be selected.
16 Wireless cooking sensor
To use PerfectCook Sensor, you must purchase a wire-
less cooking sensor.
You can purchase the wireless cooking sensor from
customer service, in our online shop or in a specialist
shop www.bosch-home.com.
16.1 Scope of delivery
After unpacking all of the parts, check for any transport
damage and for completeness of delivery.
¡
Wireless cooking sensor
¡
Silicone patch
¡
Template
16.2 Attaching the silicone patch
The silicone patch secures the cooking sensor to the
cookware. For fitting on the cookware:
1.
Clean and dry the cookware thoroughly. Ensure that
there are no grease residues in the adhesive area.
2.
Remove the protective film from the silicone patch.
Adhere the silicone patch to the outside of the cook-
ware in the correct place using the enclosed tem-
plate as a guide.
3.
Press down all over the surface of the silicone
patch, including in the centre.
4.
Leave the adhesive to dry for one hour. Do not use
or rinse out the cookware during this time.
Note:
If the silicone patch comes loose, use a new
one. If required, you can purchase a set with five silic-
one patches from specialist retailers, from our cus-
tomer service or on our official website www.bosch-
home.com by quoting the article number 17007119.
All adhesives break down over time when they are
stored. To prevent this from happening, place the silic-
one bases on their containers as soon as they are
cleaned.
16.3 Attaching the wireless cooking sensor
1.
Ensure that the silicone patch is completely dry be-
fore attaching the cooking sensor.
2.
Attach the cooking onto the silicone patch so that it
fits perfectly.
