English |
7
Bosch Power Tools
1 609 92A 0HH | (18.11.13)
Technical Data
Assembly
Delivery Scope
Please also observe the representation of
the delivery scope at the beginning of the op-
erating instructions.
Before assembling the saw stand, check if all
parts listed below are provided:
Assembling the Saw Stand
– Carefully remove all parts included in the delivery from
their packaging.
– Remove all packaging material.
Setting Up the Saw Stand (see figures A1
–
A2)
– Lay the saw stand upside down on the floor (legs facing up-
ward).
– Push the locking pin
6
in and tilt the leg upward until the
locking pin can be heard to engage.
– Repeat this workstep with the other three legs.
– Turn around the saw stand to the working position.
– Ensure that the saw stand is stable and that all locking pins
have engaged.
The saw stand is easily aligned with the height-adjustable leg
7
.
– Loosen lock nut
14
and screw the leg in or out until the saw
stand is aligned level and all four legs face against the floor.
– Tighten the lock nut
14
again.
Mounting the Workpiece Support (see figure B)
– Insert the workpiece support
3
into the table extension
2
.
– Tighten the locking knob
1
to lock the workpiece support.
– Repeat the worksteps with the second workpiece support.
Preparing the Saw Stand
Preparing the Attachment Sets (see figures C1
–
C2)
– Insert two carriage bolts
9
at a time from below into the slot
of the attachment set and secure the bolts using the nut
locking devices
10
to prevent them from falling out.
– Repeat the worksteps with the second attachment set.
– Measure the distance
x
between the mounting holes and
your power tool.
– Position the attachment sets
5
centred on the saw stand
and at the matching clearance
x
to each other.
Place both attachment sets
5
on the saw stand in such a
manner that the labelling can be read.
– Screw the locking knob
8
into the corresponding hole of
the attachment set
5
.
Fastening the Power Tool to the Attachment Sets
(see figures D1
–
D2)
– Position the power tool in the transport position.
Notes on the transport position are given in the operating
instructions of the respective power tool.
– Position the movable carriage bolts
9
in the attachment
sets so that they match the mounting holes of the power
tool.
– Lower the power tool onto the carriage bolts
9
and fit the
attachment set and power tool using the washers
11
,
spring washers
12
and nuts
13
.
– Tighten the locking knobs
8
of the attachment sets.
Saw stand
PTA 1
Article number
3 603 M05 4..
Length of saw stand without table
extension
mm
1010
Length of saw stand with table
extension
mm
2400
Height of saw stand
mm
825
Max. carrying capacity (power tool +
workpiece)
without table extension
– Attachment set
kg
115
Max. carrying capacity (power tool +
workpiece)
with table extension
– Attachment set
– Per table extension
kg
kg
85
15
Weight according to EPTA-Procedure
01/2003
kg
12
No.
Designation
Quantity
Saw stand PTA 1
1
5
Attachment set
2
8
Locking knob of the attachment set
5
2
4
Locking knob of the table extension
2
2
3
Workpiece support
2
9
10
11
12
13
Fastening kit
consisting of:
– Carriage bolt
– Nut locking device
– Washer
– Spring washer
– Nut
4
4
4
4
4
OBJ_BUCH-2132-001.book Page 7 Monday, November 18, 2013 2:34 PM
