Installation and connection
en
7
B) Flush installation
1.
Complete a normal installation of the appliance
making sure that it is surrounded by a uniform slot.
The hob surface should be slightly below the work
surface.
For tile worktops, if necessary, raise the bearing
surfaces with strips resistant to water and
temperatures.
2.
Check the operation and position of appliance.
3.
Fill the gap between the worktop and hob with
conventional silicone adhesive appropriate in the
colour you desire.
Note:
If unsuitable silicone adhesive is used on
natural stone surfaces then this can produce colours
that can not be removed. Our Technical Assistance
Service can provide you with the most suitable glue
(code 310818). Please note the manufacturers
instructions for use.
4.
Smooth the silicone adhesive with a scraper or wet
finger moistened with soap and water before it forms
a layer.
5.
Allow the silicone adhesive to dry before using the
appliance.
Electrical connection
An electrical 10 amp socket needs to be within 1 m of
the hotplate to allow electrical connection. The socket
must remain accessible after installation of the appliance.
Important notes:
■
This appliance is connected to the mains (240 VAC)
by means of the connecting lead which must be
fixed to the kitchen unit to prevent it from coming
into contact with hot parts of the cooktop (or an oven
installed underneath) and remain accessible after
installation of the cooktop.
When making this connection make sure that the
lead cannot come into contact with hot parts of the
cooktop.
■
This appliance must be earthed. When connecting
the cooktop ensure that the earth wire is connected
first and that all wires are connected to the correct
terminals.
Wiring diagram
A
Switch
B
Blue wire
C
Brown wire
D
Terminal
E
Ignition module
VLOLFRQH
/
9
9
1
99 a
