Bosch PAM 220, Original Instructions Manual

Page: 24 / 183

24 | English
Digital angle measuring device PAM 220
Dimensions 425 × 41 × 58 mm
A) Only non-conductive deposits occur, whereby occasional temporary conductivity
caused by condensation is expected.
The serial number (13) on the type plate is used to clearly identify your measuring tool.
Assembly
Inserting/Replacing Batteries (see figure A)
It is recommended that you use alkaline manganese batteries to operate the
measuring tool.
Press the locking mechanism
(14) to open the battery compartment cover
(15) and remove the battery compartment cover. Insert the batteries/re-
chargeable batteries. When inserting the batteries, ensure that the polarity
is correct according to the illustration on the inside of the battery compart-
ment.
When the battery low indicator
(b) is shown in the display for the first time
during operation, measurements can be made for only about 1–2 hours.
When the battery low indicator
(b) flashes, the batteries/rechargeable bat-
teries must be replaced. It is no longer possible to carry out measurements.
Always replace all the batteries at the same time. Only use batteries from the
same manufacturer and which have the same capacity.
u
Take the batteries out of the measuring tool when you are not using it
for a prolonged period of time
. The batteries can corrode and self-dis-
charge during prolonged storage.
Attaching the Leg Extension (see figure B)
Slide the leg extension (2) from the front onto the fold-out leg (1) . Push the
leg extension as far as required over the joint of the measuring tool.
Operation
Starting Operation
u
Protect the measuring tool from moisture and direct sunlight.
1 609 92A 56P | (12.07.2019) Bosch Power Tools