Bosch PAD 10000, Instructions For Use Manual

Page: 13 / 40

9
User troubleshooting of
minor faults
The compressor will not start, or stops
for no apparent reason
● Ascertain whether the humidity level set
has been reached.
● Check that the power supply is in order. If
it is, wait 10 minutes before restarting the
appliance.
● Check that the water tank 4 is properly in
place, and reposition if necessary.
● Check whether the frost protection
thermostat has switched the appliance
off.
Insuffi cient dehumidifying capacity is
available
● Remove and clean Filter 6 .
● Check whether the air inlet 2 or air outlet
aperture 3 is obstructed.
● The temperature or the ambient humidity
level may be too low.
If it proves impossible to rectify the
fault, immediately unplug the appliance
from the power supply and contact our
customer service.
Disposal
A
This appliance is labelled according to
European Directive 2002/96/EG relating to
Waste Electrical and Electronic Equipment
(WEEE). This Directive sets out the
framework for the EU-wide take-back and
recycling of end-of-life appliances.
Please ask your specialist retailer about the
current arrangements for disposal.
The appliance contains refrigerant, which
must be disposed of according to the
provisions currently in force.
Guarantee
The guarantee conditions for this appliance
are as defi ned by our representative in the
country in which it is sold. Details regarding
these conditions can be obtained from
the dealer from whom the appliance was
purchased. The bill of sale or receipt must
be produced when making any claim under
the terms of this guarantee.
Right of modifi cation reserved.
en