58
en | Network
AUTODOME IP starlight 7000i
2020-07 | v0.7 |
User Manual
Bosch Security Systems
Requested total
The value in this field is the total number of watts from the fields
Requested for camera
and
Additional Power
.
Allocated power
The value in this field is the number of watts of allocated power to the camera.
8.5
Network Management
SNMP
The camera supports the SNMP V1 (Simple Network Management Protocol) for managing and
monitoring network components, and can send SNMP messages (traps) to IP addresses. The
unit supports SNMP MIB II in the unified code. If you wish to send SNMP traps, enter the IP
addresses of one or two required target devices here.
If you select
On
for the
SNMP
parameter and do not enter an SNMP host address, the camera
does not send them automatically, but only replies to SNMP requests. If you enter one or two
SNMP host addresses, SNMP traps are sent automatically. Select
Off
to deactivate the SNMP
function.
1. SNMP host address / 2. SNMP host address
If you wish to send SNMP traps automatically, enter the IP addresses of one or two required
target units here.
SNMP traps
You can select which traps are to be sent.
1.
Click
Select
. A list is opened.
2.
Click the checkboxes to select the required traps. All the checked traps will be sent.
3.
Click
Set
to accept the selection.
UPnP
Select
On
to activate UPnP communication. Select
Off
to deactivate it.
When the Universal Plug-and-Play (UPnP) function is activated, the unit responds to requests
from the network and is automatically registered on the requesting computers as a new
network device. This function should not be used in large installations due to the large number
of registration notifications.
Note:
To use the UPnP function on a Windows computer, both the Universal Plug-and-Play Device
Host and the SSDP Discovery Service must be activated.
The priority of the different data channels can be set by defining the DiffServ Code Point
(DSCP). Enter a number between 0 and 252 as a multiple of four. For alarm video you can set
a higher priority than for regular video and you can define a Post Alarm Time over which this
priority is maintained.
8.6
Multicast
The camera can enable multiple receivers to receive the video signal simultaneously. The
stream is either duplicated and then distributed to multiple receivers (Multi-unicast), or it is
sent as a single stream to the network, where it is simultaneously distributed to multiple
receivers in a defined group (Multicast).
Summary of Contents for MIC IP starlight 7000i
Page 2: ......
Page 84: ...84 Support AUTODOME IP starlight 7000i 2020 07 v0 7 User Manual Bosch Security Systems ...
Page 85: ......
