Bosch MAP Control Center IUI-MAP0001-2, User Manual

Page: 22 / 64

22 en | Operation MAP Control Center
2014.11 | 06 | F.01U.168.328 User Manual Bosch Sicherheitssysteme, GmbH
– If you wish to enter the Smartkey token’s ID number at the control center, press Enter
Smartkey Token Number . The Enter Smartkey Token Numbe r keypad screen ( Figure
2.21 Enter Smartkey Token Number keypad screen, page 22 ) opens. Refer to Table 2.3
Arming indicators, page 15 for information about using the commands at the bottom of
the screen.
–
Use the on-screen keypad to enter the 8-character ID found on the Smartkey token.
The code appears in the
Enter field and a Verify Code field appears.
– Enter the same code again. The code appears in the Verify Code field.
– Press OK .
If the token number in the Enter field matches the number entered in the Verify
Code field, the Smartkey token number appears in lighter text under the Enter
Smartkey Token Numbe r button name on the Add Smartkey User screen. If these
numbers do not match, an error message is displayed, and you must re-enter the
token number and verify code.
Figure 2.21 Enter Smartkey Token Number keypad screen
– On the Add Smartkey User screen ( Figure 2.20 Add Smartkey User screen, page 21 ), press
Select Smartkey Profile . The Select Smartkey Profile screen ( Figure 2.23 Select Smartkey
Profile screen, page 23 ) opens.
Notice!
If no Smartkey profiles are programmed, the message Attention - Use RPS to Add Smartkey
Configuration ( Figure 2.22 Attention – Use RPS to Add Smartkey Configuration, page 23 )
appears.