Bosch LTE 65EU, Manual

Page: 11 / 40

Installation | 3
Bosch Motorsport Telemetry_System_LTE65_Manual 11 / 40
3.3 Pit Stand Installation
The pit stand antenna available from Bosch Motorsport is a dual 4G MIMO antenna with
3G fallback, both MIMO antennas are in the same housing. This antenna should be in-
stalled in an open location not obstructed by carbon fiber or metal objects.
Pit stand harness specifications
Min Supply Voltage 8 V DC
Max Supply Voltage 18 V DC
Power Consumption 6 W
Power Mating Connector DTM06-2S
Power Mating Connector Pinout 1=Bat Pos, 2=Bat Neg
3.4 Safety Notices
CAUTION
Disconnect power before handling of the antenna.
CAUTION
LTE65-EU: Keep a minimum safety distance of 5 cm from the human
body to the antenna.
LTE65-JP and LTE65-US: Keep a minimum safety distance of 20 cm
from the human body to the antenna.
3.5 Antenna Installation
When installing antennas, ensure that you are not spinning the cable or antenna body rel-
ative to the LTE65. To tighten the SMA connection, only turn the collar of the cable or an-
tenna. Spinning the entire cable or antenna can lead to damage of the internal co-ax
cable of the LTE65 and reduced RF performance. It is also recommended to tighten the
SMA connections to 3 in-lbf (0.3 Nm). SMA specific torque wrenches are available from
many retailers.
3.6 Receiver Ethernet Connection
Note that an LTE65 receiver must be plugged directly into a computer and not into a
switch or router. USB to Ethernet adaptors are ok to use with the computer. When the
device is used as a receiver with an Ethernet connection, it will act as a DHCP server and
assign an IP to the connected computer. The default configuration for LTE65 IP and DHCP
is 10.10.0.235/24 with a lease range from 10.10.0.65-69.
Static IP addresses are not recommended, as the LTE65 receiver may not reliably detect
the IP of the connected laptop.