LTC 8555 Series |
Instruction Manual
|
Installation
EN
| 15
Bosch Security Systems | 29 August 2003
If using the LTC 8059 Master Control Software, while
online, select the Command Script tab and enter the
script for your connection type exactly as it appears in
the table below:
After the script has been entered, download the script
into the Allegiant CPU. Reset the system by powering
the CPU off/on, or by entering
Keyboard User Function 15
on an operating keyboard. The specified port will begin
to operate in the keyboard mode. The port will remain
in the keyboard mode unless manually cancelled by
entering
Ctrl-C
several times using Windows
HyperTerminal program, operating at 9600 baud.
The keyboard can now be physically connected to
the Allegiant according to details shown in FIGURE 6.
For modem connections, refer to the next section and
FIGURE 7.
Once the keyboard is in communication with the
Allegiant, camera and monitor numbers will appear in
the LED displays.
Figure 6: Direct Connection to Allegiant’s Console/Printer Port
Allegiant system main
CPU bay
CONSOLE port on Allegiant
system must be configured
for
RS-232 Keyboard mode
(refer to text for details)
Junction box and power
adapter supplied with
LTC 8557 kit
User-supplied female
9-pin D connector.
3 m (10 ft) data/
power cable
supplied with
keyboard
User-supplied cable or other link
suitable for
full duplex RS-232 transmissions
at 9600 baud
Console pin 2 (Rx) to Tx of link or directly to pin 3 of LTC 8557 box.
Console pin 3 (Tx) to Rx of link or directly to pin 2 of LTC 8557 box.
Console pin 7 (Gnd) to Data Gnd of link or directly to pin 1 of LTC 8557 box.
Keyboard interface
connection type
Command Script
Direct to Console port
Begin @boot
(except LTC 8900)
SET-PORT-RS232 0 4 8 0 1 0
_SET_KBD_MODE 0 1
break
Direct to Printer port
Begin @boot
(except LTC 8900)
SET-PORT-RS232 4 4 8 0 1 0
_SET_KBD_MODE 4 1
break
Modem connected to
Begin @boot
Console port
SET-PORT-RS232 0 4 8 0 1 1
(except LTC 8900)
_SET_KBD_MODE 0 1
break
Modem connected to
Begin @boot
Printer port
SET-PORT-RS232 4 4 8 0 1 1
(except LTC 8900)
_SET_KBD_MODE 4 1
break
Direct to Controller port
Begin @boot
(LTC 8900 only)
SET-PORT-RS232 0 4 8 0 1 0
_SET_KBD_MODE 0 1
break
Direct to Console port
Begin @boot
(LTC 8900 only)
SET-PORT-RS232 4 4 8 0 1 0
_SET_KBD_MODE 4 1
break
Modem connected to
Begin @boot
Controller port
SET-PORT-RS232 0 4 8 0 1 1
(LTC 8900 only)
_SET_KBD_MODE 0 1
break
Modem connected to
Begin @boot
Console port
SET-PORT-RS232 4 4 8 0 1 1
(LTC 8900 only)
_SET_KBD_MODE 4 1
break
