Bosch Security Systems | 13 February 2004
5
OPERATION
5.1
RUN Button and Indicator
Momentary depression of the
RUN
button initiates
automatic sequencing known as the
run
mode. The
Green LED above this button will indicate the switcher
is in the
run
mode.
5.2
DWELL Control
This control is located on the rear panel. This
adjustment controls the rate at which the cameras are
sequenced during the
run
mode. Rotating the control
clockwise slows the rate of sequencing (increases the
dwell time). Rotating the control counter-clockwise
causes the switcher to sequence faster (decreases the
dwell time). The dwell time is approximately 2 seconds
when the control is turned fully counter-clockwise; full
clockwise rotation of the control provides a dwell time
of approximately 45 seconds.
5.3
Camera Buttons and Indicators
These buttons are used to call-up a camera and stop
automatic sequencing. When a camera button is
pressed, that camera will be called-up to the monitor
screen, the camera LED indicator will light, and the
RUN LED indicator will go out.
LTC 5121, LTC 5141 |
Instruction Manual
|
Operation
EN
| 8
Figure 1 Front and Back Panels
6
ILLUSTRATIONS
6.1
LTC 5121/60, LTC 5121/50
