1 689 989 038
2013-08-16
|
Robert Bosch GmbH
20 | KTS 340 | Symbols used
en
1. Symbols used
1.1
In the documentation
1.1.1
Warning notices - Structure and meaning
Warning notices warn of dangers to the user or people in
the vicinity. Warning notices also indicate the consequenc-
es of the hazard as well as preventive action. Warning no-
tices have the following structure:
Warning
symbol
KEY WORD – Nature and source of hazard!
Consequences of hazard in the event of fail-
ure to observe action and information given.
¶
Hazard prevention action and information.
The key word indicates the likelihood of occurrence and
the severity of the hazard in the event of non-observance:
Key word
Probability of
occurrence
Severity of danger if in-
structions not observed
DANGER
Immediate
impend-
ing
danger
Death
or
severe
injury
WARNING
Possible
impending
danger
Death
or
severe
injury
CAUTION
Possible
dangerous
situation
Minor
injury
1.1.2
Symbols in this documentation
Symbol Designation
Explanation
!
Attention
Warns about possible property damage.
i
Information
Practical hints and other
useful information.
1.
2.
Multi-step
operation
Instruction consisting of several steps.
e
One-step
operation
Instruction consisting of one step.
Intermediate
result
An instruction produces a visible inter-
mediate result.
"
Final result
There is a visible final result on com-
pletion of the instruction.
1.2
On the product
!
Observe all warning notices on products and ensure
they remain legible.
2. User information
2.1
Important notes
Important information on copyright, liability and warran-
ty provisions, as well as on equipment users and com-
pany obligations, can be found in the separate manual
"Important notes on and safety instructions for Bosch
TEST EQUIPMENT". These instructions must be carefully
studied prior to start-up, connection and operation of
the KTS 340 and must always be heeded.
2.2
Safety instructions
All the pertinent safety instructions can be found in the
separate manual "Important notes on and safety in-
structions for Bosch TEST EQUIPMENT". These instruc-
tions must be carefully studied prior to start-up, con-
nection and operation of the KTS 340 and must always
be heeded.
2.3
Electromagnetic compatibility (EMC)
The KTS 340 is a class B product as per EN 61 326.
2.4
Open Source Software
A list of the open source software licenses for the
KTS 340 can be found in an Adobe PDF document on
the “
ESI[tronic] Startcenter
” DVD.
2.5
Pass-Thru Mode (SAE J2534)
i
The "
(Info) >> Help
" menu in the Online Help
contains all the necessary information on Pass-Thru
mode.
2.6
R&TTE Directive
The KTS 340 is a class 1 wireless device (R&TTE
1999/55/EC) approved for use in Europe. In France, use
of the KTS 340 is only permissible indoors.
i
In non-European countries the corresponding nation-
al regulations on the operation of wireless devices
in the 2.4 GHz frequency band must be heeded (e.g.
WLAN or Bluetooth).
Disposal
Dispose of used electrical and electronic
devices, including cables, accessories and
batteries, separately from household waste.
2.7
Measuring category according to
EN 61010-2-030:2010
EN 61010-1:2010 specifies the general safety require-
ments for electrical testers and measuring devices and
defines the measuring categories from 0 to IV in the
section EN 61010-2-030:2010.
The KTS 340 is intended for use in measuring category
0, i.e. for measurements in circuits with
no
direct con-
nection to the mains voltage.
