Constant Response Circuitry
The internal electronic feedback system
provides a "soft start", which will reduce
the stresses that occur from a high
torque start. The system also maintains
t h e s e l e c t e d s p e e d u n d e r l o a d f o r
maximum efficiency.
Blade Orbit Selector Lever
M a x i m u m c u t t i n g e f f i c i e n c y c a n b e
obtained by adjusting the blade orbit
selector lever to suit the material being
cut.
T h e f o l l o w i n g c h a r t w i l l h e l p y o u
determine which setting to use for your
application. This chart is intended as a
guideline only, and test cuts in scrap
material should be performed first to
determine the best setting.
Setting O
Hard materials such as
m e t a l s o r t h i n s h e e t
metals. This setting can
b e u s e d w i t h k n i f e
blades, grit edge blades,
r a s p w o r k a n d d o w n
cutting blades.
Setting I
S o f t m a t e r i a l s w h e r e
c l e a n e r
c u t t i n g
o r
delicate scrolling work is
performed.
Setting II
M e d i u m
d e n s i t y
materials such as harder
woods or particle board.
Setting III
Soft materials such as
wood, plastics, etc. and
w h e n f a s t c u t t i n g i s
more important than a
clean cut.
Chip Blower
Your jig saw is equipped with a two
position chip blower to help keep the
cutting line clear of chips.
By adjusting the chip blower lever the
force of the discharge air may be altered
as follows;
BLOWER SWITCHED ON
For working with wood,
p l a s t i c
a n d
s i m i l a r
m a t e r i a l s t h a t p r o d u c e
large amounts of sawdust.
BLOWER SWITCHED OFF
For working with metals
and when cooling agents
a r e u s e d , o r w i t h d u s t
collection accessory.
Footplate Angle Adjustment
The footplate may be tilted to allow
angle cuts up to 45° in either direction
(Fig. 8).
Note:
before adjusting the footplate,
remove dust shroud and anti-splinter if
used.
Open the lock lever to unlock footplate.
P u s h a n d h o l d t h e f o o t p l a t e f i r m l y
towards the back of tool as shown.
While holding the footplate backwards
tilt footplate to desired angle on bevel
s c a l e , t h e n r e l e a s e p r e s s u r e o n
footplate so it engages into detent at
desired angle (Fig. 8).
1
LOCK
LEVER
BEVEL
SCALE
FOOTPLATE
FIG. 8
-12-
Operating Instructions
Summary of Contents for JS572E
Page 54: ... 54 Notes Remarques Notas ...
Page 55: ... 55 Notes Remarques Notas ...
