5.3
Commercial Series Motion Detector with
14
en | Installation
Anti-mask
Notice!
Using a mounting bracket might reduce catch performance.
�
Always mount the detector within the recommended mounting height, with or without a
�
mounting bracket.
�
Brackets are not investigated by UL.
�
Brackets are not EN50131 compliant.
�
Notice!
Do not use the bracket to tip the detector vertically, unless you intend to compensate for a
non-vertical surface. It may cause false alarms or reduced catch performance.
Wire knockouts
Use the following figure to determine the knockouts to use for the desired installation.
1
2
3
4
Figure 5.5: Wire knockout locations
Callout
ᅳ
Description
1
ᅳ
Surface wiring knockout, detector’s left side
2
ᅳ
Through-the-wall wiring knockout
3
ᅳ
Surface wiring knockout, detector’s right side
4
ᅳ
Through-B328-bracket wiring knockout*
* If you use the bracket mount knockout for wires, run the wires between the walls marked
in red in the figure. With the wiring between the walls and behind the terminal block, other
features, such as EOL resistor jumper pins, cannot interfere with or puncture the wires.
2017.09 | 03 | F.01U.309.350
Reference Guide
Bosch Security Systems, Inc
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
