Bosch INDEGO 350, Original Instructions Manual

Page: 27 / 398

English | 27
Online Support
http://www.bosch-indego.com
Problem Possible Cause Corrective Action
The LED on the dock-
ing station flashes The perimeter wire is interrupted, too long
or too short. Wire not connected and
mower not in the docking station. Check that the perimeter wire is not interrupted and is
between 20 and 250 meters in length. Then switch
power supply off and then on again.
Follow instructions in Installation Guide on installing the
mower.
Excessive vibrations/
noise Blade bolt loose Tighten blade bolt to torque of 2.5 Nm.
Cutting blade damaged/bent Replace cutting blade (see figure K ).
Mower not docking
reliably Perimeter wire not properly layed out
around docking station Follow instructions in Installation Guide on layout of peri-
meter wire.
Perimeter wire close to a source of interfer-
ence Remove any excess (e.g. coiled up) perimeter wire
around the docking station.
Change perimeter wire ID in the menu.
Mower fails to operate Isolator switch not turned on Remove mower out of docking station, turn isolator
switch on and place mower back into docking station (en-
sure docking station is on – LED lights up green).
Possible clogging Always turn isolator switch off first, then check under-
neath the mower and clear out as necessary (always wear
protective gloves).
Battery not fully charged Place mower in the docking station to allow to charge.
Docking station must be powered on.
Grass too long Mow lawn with conventional lawnmower to its lowest
height-of-cut setting before using the mower.
Battery too hot/cold The mower operates when the battery internal battery
temperature is between 5 °C – 45 °C. Allow mower to
cool down/warm up. If the error occurs frequently, the
docking station should be positioned in the shade.
Mower standing on
lawn with the display
switched off Problems whilst running Press confirm button for screen to light up, or place
mower in docking station.
Mower does not
charge Battery too hot/cold The mower operates when the battery internal battery
temperature is between 5 °C – 45 °C. Allow mower to
cool down/warm up. If the error occurs frequently, the
docking station should be positioned in the shade.
Docking station not switched on Switch on power supply to docking station. If docking
station does not start, contact your Bosch Service
Centre.
Charging pins corroded Clean the charging pins.
Bosch Power Tools F 016 L81 848 | (01.10.2018)