15
Catalytic cooking compartment panels
The catalytic cooking compartment panels are coated with self-
cleaning enamel.
The surfaces clean themselves while the oven is in operation.
Larger splashes will only be removed after the oven has been
used several times.
The rear and side walls are covered with catalytic panelling.
Never clean these surfaces with oven cleaner. Slight
discolouration of the enamel does not affect self-cleaning.
Removing and fitting the appliance door
You can remove the appliance door to clean it more
thoroughly.
Removing the appliance door
:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. When removing the oven door, ensure that the locking
pins are fully inserted into the holes in the hinges.
1.
Open the oven door fully.
2.
Lock both hinges on the left and right using a locking pin
(a)
.
Note:
The locking pins must be fully inserted into the holes in
the hinges.
3.
Grip the oven door on either side with both hands and close
the oven door by approx. 30°
(b)
.
4.
Raise the oven door slightly and pull it out.
Note:
Do not fully close the oven door. The hinges may
become bent and the enamel may be damaged.
Fitting the appliance door
1.
Grip the oven door on either side with both hands.
2.
Slide the hinges into the slots in the oven
(a).
Note:
The notch below the hinges must engage into the
frame of the oven
(b)
.
3.
Lower the door downwards.
4.
Remove the locking pins.
:
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call after-sales service.
Removing and inserting the hook-in racks
You can remove the hook-in racks for easier cleaning.
Removing the hook-in racks
1.
Unscrew the right and left-hand screws on the hook-in rack.
2.
Remove the hook-in rack.
Inserting the hook-in rack
1.
Hold the hook-in rack in front of the drill holes in the side
panel.
2.
Screw in the hook-in rack tight again using the screws.
Enamel surfaces
(smooth surfaces)
To facilitate cleaning, you can switch on
the interior lighting and detach the appli-
ance door if necessary. Apply ordinary
washing-up liquid or a vinegar solution
with a soft, damp cloth or chamois
leather; dry with a soft cloth. Loosen
baked-on food residues with a damp
cloth and detergent. We recommend
using oven-cleaning gel for heavy depos-
its of dirt. This can be applied to the
affected area. Leave the cooking com-
partment open after cleaning to allow it
to dry.
Self-cleaning sur-
faces (rough sur-
faces)
Please see the notes in section: Self-
cleaning surfaces
Door panels
Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Glass cover for the
oven light
Hot soapy water:
Clean with a dish cloth.
Seal
Do not remove.
Hot soapy water:
Clean with a dish cloth. Do not scour.
Shelf
Hot soapy water:
Soak and clean with a dish cloth or
brush.
Accessories
Hot soapy water:
Soak and clean with a dish cloth or
brush.
Area
Cleaning agents
D
E
D
E
Summary of Contents for HSB738356M
Page 2: ......
Page 34: ......
Page 51: ......
Page 52: ...HSB738356M π à ùªdG óbƒªdG ar ɪ à S G π dO 914775362 930415 9000892069 9000892069 ...