Section 4 Component Teardown
4-5
Hood Fan Motor Removal
1. Disconnect the power supply cord, remove oven
from wall, then remove outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Disconnect the 6-pin connector of the hood fan
motor from the main wire harness located at the
right edge of the hood duct and release the snap
band from the hood duct. Remove one (1) screw
holding the Hood fan motor on the rear cavity.
5. Remove hood fan motor from the oven cavity top
plate by lifting it up. Hood fan motor is now free.
Thermal Cut-Out (Cavity) Removal
1. Disconnect the power supply cord, remove oven
from wall, then remove outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Disconnect the wire leads from the thermal cut-out
(cavity).
5. Remove the thermal cut-out (cavity) from the holder
at the air duct.
Cooling Fan Motor Removal
1. Disconnect the power supply cord, remove oven
from wall, then remove outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
5. Remove the one (1) screws holding the fan guide
to back wind guide.
6. Push up the fan guide and remove it from back
wind guide.
4. Disconnect the wire leads from the fan motor.
7. Remove two (2) screws holding the fan motor to fan
guide.
8. Remove the fan motor from the fan guide and the fan
blade by pulling the fan motor with your hand. The
fan blade will fall as the motor is removed.
INSTALLATION
1. Pick up the fan blade with one hand and insert the
fan motor shaft into the fan blade hole with the
other hand.
2. Install fan motor to fan guide with two (2) screws.
3. Re-install the fan guide to the back wind guide with
4. Reconnect the wire leads to the fan motor.
5. Re-install the outer case.
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of the
high-voltage capacitor (that is the connecting lead of
the high-voltage diode) against the chassis with the
use of an insulated screwdriver.
NOTE
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of the
high-voltage capacitor (that is the connecting lead of
the high-voltage diode) against the chassis with the
use of an insulated screwdriver.
NOTE
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of the
high-voltage capacitor (that is the connecting lead of
the high-voltage diode) against the chassis with the
use of an insulated screwdriver.
NOTE
Do not hit the fan blade strongly when installing
because the bracket may be deformed.
Make sure that the fan blade rotates smoothly
after installation.
Make sure that the axis of the shaft is not
slanted.
CAUTION
one (1) screw.
Thermal Cut-Out (Cavity)
