4-2
Hood Exhaust Louver Removal
Remove the oven from the wall and proceed as follows:
1. Disconnect the power supply cord.
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60
seconds.
4. Remove the two (2) screws on the top holding the
hood exhaust louver to the oven cavity front face
plate.
5. Pull the hood exhaust louver from the oven cavity by
pushing the left tab of the hood exhaust
louver to remove.
6. Now, the hood exhaust louver is free.
Removal Of Oven From Wall
1. Disconnect the power supply cord, and uncoil the
power supply cord.
2. To discharge the high voltage capacitor, wait for 60
seconds.
3. Remove the turntable tray and support from the
oven cavity.
4. Remove the three (3) screws holding the oven
(outer case cabinet) to the top cabinet.
5. While supporting the front of the oven,and release
the oven from the unit mounting plate.
6. Pull the power cord out of the wall cabinet and
remove the oven.
7. The oven is now free and can be placed on the work
surface selected for servicing the oven.
8. Installation is the reverse of this procedure.
The following adjustments or component replacement
can be performed without removing the oven from the
wall:
1. Hood lamps, sockets, grease filter and charcoal filter.
2. Base cover and hood lamp glass assembly.
3. Turntable motor.
4. Hood exhaust louver.
5. Control assembly or components.
NOTE
Two persons are recommended to remove the oven
from a wall installation.
NOTE
6. Door assembly or components.
Section 4 Component Teardown
Push
Push
Hood Exhaust
Louver
Figure 4-1.
