Bosch HGG343456M, Instruction Manual

Page: 16 / 24

16
Grilling with the rotary spit
The rotary spit is particularly good for cooking large roasts,
such as rolled roasting joints or poultry. The meat becomes
crispy and brown.
Preparing roasts
To ensure that the roast is well-browned and cooked evenly,
observe the following points:
Skewering and securing the meat to the spit
Position the roast as close as possible to the centre of the
rotary spit.
Use the clamps to secure the roast at both ends. The rear
clamp must be a minimum of 7 cm from the end of the spit.
You may also use cooking string to bind and secure the roast.
When spit roasting poultry, bind the ends of the wings
underneath the back and secure the thighs to the body. This
prevents them from overbrowning. Pierce the skin on the
underside of the wings to allow the fat to escape.
The section
Tested for you in our cooking studio contains
many setting values for grilling with the rotary spit.
Select the appropriate oven temperature from the information
given in the table. If the temperature is too high, the meat or
poultry will burn on the outside, while inside it will remain largely
uncooked.
Inserting the rotary spit
1.
Place the rotary spit holder on the baking tray (Fig. A).
2.
Place the rotary spit in the holder (Fig. B).
3.
Insert the baking tray at level 1. There is an opening in the
back wall of the oven. The rotary spit hooks into this (Fig. C).
4.
Remove the handle and close the oven door (Fig. D).
Care and cleaning
With attentive care and cleaning, your hob and oven will retain
its looks and remain in good working order for a long time. We
will explain here how you should care for and clean them
correctly.
Notes
■
Slight differences in the colours on the front of the oven are
caused by the use of different materials, such as glass,
plastic and metal.
■
Shadows on the door panel which look like streaks, are
caused by reflections made by the oven light.
■
Enamel is baked on at very high temperatures. This can
cause some slight colour variations. This is normal and does
not affect operation. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.
Upper glass cover
Before opening the top cover, remove any spills with a cloth.
Use glass cleaner if possible.
For cleaning, remove the top cover. To do this, hold the cover
securely on both sides with both hands and pull it upwards.
If the cover hinges become loose, note the letters marked on
them. The hinge with the letter R must be fitted on the right, and
the hinge with the letter L must be fitted on the left.
After cleaning, re-assemble the top cover following the same
procedure in reverse order.
Only close the top cover once the burners have cooled down.
$ %
& '