Bosch HGG22B120T, Instruction Manual

Page: 14 / 24

14
6.
Keeping the function selector pressed, push the 8 ignition
button.
7.
The gas escaping from the gas grill is ignited using the
ignition button. To activate the safety ignition, press and hold
the function selector for 10 seconds.
8.
Check that the flame is lit. If it is not, repeat the process from
step 5.
9.
After 30 minutes, switch off the function selector. Once the
oven has cooled down, remove the protective plate again.
Heating up the hotplate
To remove the new appliance smell, heat up the hotplate
without a saucepan at the highest level for 3 minutes.
Cleaning the accessories
Before you use the accessories for the first time, clean them
thoroughly with hot soapy water and a soft dish cloth.
Advance cleaning of burner cup and cap
Clean the burner cap (1) and cup (2) with water and washing-
up liquid. Dry the individual parts carefully.
Place the burner cup and cap back on the burner shell (5).
Ensure that the igniter (3) and flame safety pin (4) are not
damaged.
The nozzle (6) must be dry and clean. Always position the
burner cap exactly over the burner cup.
Setting the hob
Your hob is equipped with three gas burners and one hotplate.
The following information explains how to light the gas burners
and set the hotplate.
Igniting the gas burners
Always position the burner cap exactly over the burner cup.
Openings on the burner cup are always unobstructed. All parts
must be dry.
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Turn the switch for the desired burner anticlockwise to the
large flame symbol — .
3.
Press and hold the burner knob and press the ignition button
at the same time. The gas burner ignites.
4.
Press and hold the burner knob for approximately 1-3
seconds. The safety pilot is activated. If the gas flame goes
out, the gas supply is automatically interrupted by the safety
pilot.
5.
Set the desired flame size. Between setting
û
Off and setting
—
, the flame is not stable. Therefore, always choose a setting
between
—
large and
˜
small flame.
6.
If the flame goes out again, repeat the process from step 2.
7.
To end the cooking process: Turn the burner knob
û
clockwise to the Off position.
The ignition device should not be actuated for more than 15
seconds. If the burner does not light within 15 seconds, wait for
at least one minute. Then repeat the ignition process.
The gas burner does not ignite
If there is a power cut or if the ignition plugs are damp, you can
light the gas burners with a gas lighter or a match.
Setting procedure for the electric hotplate
You can adjust the heat setting of the hotplates using the
hotplate knobs.
Proceed as follows:
1.
Open the top cover. The top cover must remain open while
the electric hotplate is in operation.
2.
Turn the switch for the electric hotplate anti-clockwise to a
suitable heat setting between 1 and 6.
3.
The electric hotplate is 145 mm in diameter. Use a pan with a
flat base and the same diameter.
4.
Set the electric hotplate switch to 0 to stop cooking.
Heat setting 1 = lowest output
Heat setting 6 = highest output
The indicator lamp lights up when the hotplate is switched on.
Type of heating 1 or 2 Depending on amount
Cooking 6
2
Start the cooking process
Continue the cooking process,
setting high or low as required
Grilling 6
4
Heat the oilStart the grilling
process
Continue the grilling process