10
Before using the oven for the first time
In this section, you can find out what you must do before using
your appliance to prepare food for the first time. Read the
Safety information
section beforehand.
Remove the appliance packaging and dispose of it
appropriately.
Setting the clock
After the appliance has been connected, the
0
symbol and
four zeros flash in the display. Set the clock.
1.
Press the
0
button.
The clock in the display shows 12:00. The time symbols light
up and the brackets are around
0
.
2.
Use the
@
or
A
button to set the clock.
After a few seconds, the time that has been set is adopted.
Baking out the oven
Precleaning the oven
1.
Remove accessories and hook-in racks from the cooking
compartment.
2.
Fully remove any remaining packaging, such as small pieces
of polystyrene, from the cooking compartment.
3.
Some parts are covered with a protective film. Remove the
protective film.
4.
Clean the outside of the appliance with a soft, damp cloth.
5.
Clean the cooking compartment with hot soapy water.
Heating up the oven
To remove the new cooker smell, heat up the oven when it is
empty and closed.
1.
Turn the temperature selector to the maximum temperature.
2.
Switch off the oven after 45 minutes.
Recleaning the oven
1.
Clean the cooking compartment with hot soapy water.
2.
Fit the hook-in racks.
Cleaning the accessories
Before using the accessories, clean them thoroughly using a
cloth and warm soapy water.
Setting the hob
In this section, you can find out how to set the hotplates.
Switching the hob on and off
You can switch the hotplate on and off with the control knobs.
Setting a hotplate
You can set the heat setting for the hotplates using the hotplate
control knobs. Press the control knob for the required hotplate
and turn it to the required heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
Note:
Hotplate temperature is regulated by the heat switching
on and off. The heat may also switch on and off at the highest
setting.
Large dual-circuit hotplate and extended
cooking zone
The size of these hotplates can be altered.
Switching on the large area
Turn the hotplate control to position 9 - where you will feel a
slight resistance - then continue turning to
õ
/
ç
symbol = large
dual-circuit hotplate or extended cooking zone
Then immediately turn it back to the desired heat setting.
Switching back to the small area
Turn the hotplate control to
Û
and reset.
The small dual-circuit hotplate is particularly good for heating
small amounts.
Caution!
Never turn the hotplate control beyond the
õ
/
ç
symbol to
Û
.
