Bosch HBL54, Installation Manual

Page: 8 / 56

Combination Oven Pre-Assembly
English 5
3. Install the decorative trim.
4. Place the microwave oven unit on top of the universal
connector brackets and fasten in place using three
screws per side. Tighten the screws securely, but do
not overtighten.
Note: The existing screws in the microwave base help
with alignment. When lowering the microwave into
place on the universal connector bracket, allow these
screw heads to slide into the slots as shown in the
illustration below. The screw nearest the front of the
microwave slides into the base of the slope at the front
of the bracket.
5. Continue with the unit installation in the following
sections on electrical connection and installing the
oven unit into the wall cabinet.
Installation with the Steam Oven
Note: Do not place the oven into the wall cabinet until after
mounting the steam oven on it using the universal connec-
tor brackets.
1. Remove the six screws holding the combo service slide
assemblies to the support bracket. Use a magnetic
screwdriver bit to reach the screws through the large
holes in the tops of the slides.
Position the decorative trim
piece so the flanges with
the holes in them face
away from the oven door.
Align the outer flanges with
the outside of the universal
brackets. Fasten with 1
screw each into the end
hole of the universal
bracket. Tighten screws
securely, but do not
overtighten.