Bosch HBJ558YS0G, User Manual And Installation Instructions

Page: 14 / 40

en
Rails
14
12.1 Cleaning recommendation
The appliance records the type and duration of the op-
eration and, if required, recommends which cleaning
function to use.
▶
When ​⁠ ​⁠ lights up in the display while the appliance
is switched off, use the cleaning function as soon as
possible.
‒
To remove the note from the display, press any
button except for the ​⁠ button. The note contin-
ues to appear until the cleaning function has
been carried out in its entirety.
‒
To reset the cleaning recommendation, press
and hold the ​⁠ button for approx. four seconds.
The note no longer appears until the appliance
has recorded the corresponding number of oper-
ations again.
Notes
¡
If the appliance is prematurely contaminated, e.g. by
greasy poultry or roasts, or if dark spots appear on
the self-cleaning surfaces, do not wait until the note
appears in the display before you use the cleaning
functions. The more often the cleaning function is
used, the longer the cleaning ability of the self-
cleaning surfaces is retained.
¡
After a power failure, the cleaning recommendation
is reset. After a power failure, it is best to start the
cleaning function.
12.2 Preparing the appliance for the
cleaning function
Carefully prepare the appliance in order to achieve a
good cleaning result.
ATTENTION!
Using oven cleaner on the self-cleaning surfaces dam-
ages the surfaces.
▶
Do not use oven cleaner on the self-cleaning sur-
faces. If oven cleaner does get onto these surfaces,
dab it off immediately using water and a sponge
cloth. Do not rub the surface and do not use abras-
ive cleaning aids.
1.
Remove accessories and cookware from the cook-
ing compartment.
2.
Detach the shelf supports and remove them from
the cooking compartment.
→
"Rails", Page 14
3.
Remove coarse dirt using soapy water and a soft
cloth:
– From the cooking compartment floor
– From the inside of the appliance door
– From the glass cover on the oven light
This prevents stubborn stains.
4.
The cooking compartment must be completely
empty.
12.3 Setting the cleaning function
Ventilate the kitchen while the cleaning function is run-
ning.
WARNING ‒ Risk of burns!
The outside of the appliance gets very hot when the
cleaning function is in progress.
▶
Never touch the appliance door.
▶
Allow the appliance to cool down.
▶
Keep children at a safe distance.
Requirement:
Prepare the appliance for the cleaning
function. → Page 14
1.
Use the function selector to set EcoClean ​⁠.
a
The display shows the duration. The duration of
one hour cannot be changed.
2.
Use the temperature selector to set the cleaning
level ​⁠.
a
After a few seconds, the cleaning function starts and
the duration counts down.
a
When the cleaning function ends, a signal sounds
and the duration is at zero in the display.
3.
Switch off the appliance.
4.
Wipe the appliance. → Page 14
12.4 Wiping the appliance after the cleaning
function
1.
Allow the appliance to cool down.
2. Wipe the cooking compartment with a damp cloth.
Note:
During operation and while the cleaning func-
tion is active, reddish patches may form on the sur-
faces. This is not corrosion but rather residue from
food that contains salt. Nutrients such as sugars
and proteins are not removed from the surface coat-
ing and may stick to the surface. These spots are
not harmful and do not impair the cleaning ability of
the self-cleaning surfaces.
3.
Attach the shelf supports.
→
"Rails", Page 14
13 Rails
To clean the rails and cooking compartment thor-
oughly, you can remove the shelf supports.
13.1 Unhooking the rails
WARNING ‒ Risk of burns!
The rails can be very hot.
▶
Never touch the rails when they are hot.
▶
Allow the appliance to cool down.
▶
Keep children at a safe distance.