7
Flush installation
Install Appliance
Electrical Installation
All model ovens on the front cover are dual rated,
designed to be connected to either 208/240V AC, 50/
60 Hz, 4 wire, single-phase power supply.
The electrical supply should be a 4-wire single-phase AC.
Install a suitable conduit box (not furnished). An
appropriately-sized, UL-listed conduit connector must be
used to correctly attach the conduit to the junction box.
NOTICE:
Local Codes may vary; installation, electrical
connections and grounding must comply with all
applicable local codes.
If local codes permit grounding through the electrical
supply neutral, connect both the white neutral wire and
the bare ground wire from the oven to the white neutral
electrical supply wire.
9
CAUTION
▯
The appliance must be disconnected from the
power supply during all installation work.
▯
The appliance must only be connected with the
power cable provided.
▯
Protection against contact must be ensured by
the installation.
Electrical Connection
The four-wire connection is preferred, but where local
codes permit, the three wire connection is also
acceptable.
9
WARNING
When connected to a 4 or 5-wire, 120/208-Volt 3-
phase power supply; the phase C conductor is not
required for the operation of the appliance.
7RS9LHZ
PP
6LGH9LHZ
èʌ¼ʓʘ
ë
èʌ¼ʓʘ
UHYHDO
èʌ¼ʓʘ
FOHDWV
UHYHDO
èʌ¼ʓʘ
FOHDWV
èʌ¼ʓʘ
IOXVKLQVHW
GHSWK
UHYHDOFOHDWV
èʌ¼ʓʘ
èʌ¼ʓʘ
IOXVKFXWRXW
KHLJKW
ʐ¼ʓʘ
PP
*
Flush installation requires a
3
/
16
" (5 mm) high x
21
15
/
16
" (557 mm) wide x 22
1
/
16
" (560 mm) deep
baseplate underneath the unit body.
Model
Dedicated circuit required
HBE5451UC
20 AMP
Summary of Contents for hbe5451uc
Page 1: ...Installation Manual Built in oven HBE5451UC ...
Page 27: ......
