Bosch GWS Professional 14-125 S, Original Instructions Manual

Page: 27 / 437

English | 27
To restart the tool, set the On/Off switch (3) to the "off" po-
sition and then switch the power tool on again.
Speed preselection
(GWS 14-125 S / GWS 17-125 S / GWS 17-125 TS / GWS
17-125 S INOX / GWS 17-150 S)
You can select the required speed using the speed preselec-
tion thumbwheel (5) , even during operation. The informa-
tion in the table below describes the recommended values.
Material Application Application tool Thumbwheel position
Metal Removing paint Sanding sheet 2–3
Metal Brushing, removing rust Cup brush, abrasive disc 3
Stainless steel Grinding Grinding disc/fibre disc 4–6
Metal Rough grinding Grinding disc 6
Metal Cutting Cutting disc 6
Stone Cutting Diamond cutting disc 6
u
The rated speed of the accessory must be at least
equal to the maximum speed marked on the power
tool. Accessories running faster than their rated speed
can break and fly apart.
Level
Speed preselec-
tion
GWS 14-125 S
GWS 17-125 S
[min -1 ]
GWS 17-125 S INOX
[min -1 ]
GWS 17-125 TS
GWS 17-150 S
[min -1 ]
1 2800 1900 2400
2 4500 3000 3800
3 6200 4100 5200
4 7900 5300 6600
5 9600 6400 8100
6 11,500 7800 9700
The values specified for speed levels are guide values.
Fitting
Fitting Protective Equipment
u
Pull the plug out of the socket before carrying out any
work on the power tool.
Note: If the grinding disc breaks during operation or the
holding fixtures on the protective guard/power tool become
damaged, the power tool must be sent to the after-sales ser-
vice immediately; see the "After-Sales Service and Applica-
tion Service" section for addresses.
Protective guard for grinding
Place the protective guard
(9) onto the holder on the
power tool until the coding
cams of the protective guard
are aligned with the holder.
When doing so, press and
hold the unlocking lever (1) .
Press the protective guard
(9) onto the spindle collar un-
til the shoulder of the pro-
tective guard is sitting on the
flange of the power tool and
rotate the protective guard
until it audibly clicks into
place.
Adjust the position of the protective guard (9) to meet the
requirements of the operation. To do this, push the unlock-
ing lever (1) upward and rotate the protective guard (9) into
the required position.
Bosch Power Tools 1 609 92A 6A0 | (11.02.2022)