14
| English
1 619 P08 931 | (31.8.10)
Bosch Power Tools
The values given are valid for a nominal voltage
[U] of 230 V. For different voltages and models
for specific countries, these values can vary.
Please observe the article number on the type
plate of your machine. The trade names of the
individual machines may vary.
Declaration of Conformity
We declare under our sole responsibility that
the product described under “Technical Data” is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
27.07.2010
Noise/Vibration Information
The measured values of the machine are listed
in the table on page 194.
Noise and vibrational values (vector sum of
three directions) determined according to
EN 60745.
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Mounting and Operation
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
Action
Figure
Page
Inserting the Saw Blade
1
195
Ejecting the Saw Blade
2
195
Switching on the blower
3
196
Mounting the splinter guard
4
196
Orbital Action Settings
5
196
Adjusting the stroke rate preselection
6
197
Switching On and Off
7
197
Lubrication when cutting metal
8
198
Plunge Cutting
9
198
Mounting the Dust Cover
10
198
Mounting and use of the parallel guide
11
199 – 200
Selecting accessories
–
201 – 202
OBJ_BUCH-1300-001.book Page 14 Tuesday, August 31, 2010 8:14 AM
Та
ше
в
-
Га
лв
ин
г
ОО
Д
www.tashev-galving.com
