Bosch GPLL5 Operating/s, Operating/Safety Instructions Manual

Page: 12 / 36

-12-
align the laser beam to the reference points. In this manner, as
an example, picture frames can be hung parallel to a stairway or
ceiling pitch.
Checking Horizontal/Vertical Lines with the Spirit Levels
(see figure E)
The tool can be used as a contractors level for checking
horizontal or vertical lines, e.g., for the level set-up of a washer
or a refrigerator. Position the tool with the aluminium supporting
surface
8 facing against the surface to be checked. When
positioning against horizontal surfaces, the aluminium
supporting surface
8 must face downward. When positioning
against vertical surfaces, the exit opening for the laser beam 9
must face upward.
Working Advice
• Keep the adhesive tape strips 4 out of the reach of
small children.
Children could mistake the strips with
chewing gum.
Mounting to a Wall
Four fastening methods are available for fastening the wall holder to
different surfaces:
• Fastening with Adhesive Tape Strips (see figure F): With the
removable adhesive tape strips 4 , the wall holder can be
fastened to sensitive or delicate sturctural materials without
causing damage to them. The structural surface must be
straight, firm, dry, grease-free and have a temperature of at least
15 °C . Pull off one of the protective foils from an adhesive tape
strip ( ) and position the adhesive tape strip onto the back
side of the wall holder ( ) in such a manner that its end
projects out. Pull off the second protective foil ( ) and firmly
press the wall holder with the adhesive tape strip against the
structural surface ( ) for at least five seconds. To remove the
wall holder, pull out the adhesive tape strip by the projecting end
slowly and as parallel as possible to the structural surface ( ).
• Fastening with Pins (see figure G): With the pins 2 provided,
the wall holder can be fastened to drywall or wooden walls.
Insert the pins through the openings in the wall holder as shown
in the figure.
• Fastening with a Screw: Place the wall holder 1 via the
opening on the back side onto a screw that projects lightly out of
the wall.
• Fastening with Adhesive Tape (see figure H): The wall holder
can also be fastened with commercially available adhesive tape
(not included in the delivery scope) as shown in the figure.
1
2
3
4
5