English |
19
1 609 92A 3WU | (12.6.17)
Bosch Power Tools
During the charging procedure, the
handle of the machine warms up. This is
normal.
If you are not planning to use the power
tool again soon, disconnect it from the
power supply.
The power tool cannot be used during
the charge procedure; it is not defective
when inoperative during the charging
procedure.
Observe the notes for disposal.
Changing the Tool
Do not use double-sided screw-
driver bits that are longer than
25 mm.
Slide the rotational direction switch
3
into the middle position. This locks the
spindle in place, preventing the drive
from starting up when the tool bit is
changed.
Insert the screwdriver bit
1
directly into
the tool holder
2
.
Operation
Starting Operation
Reversing the rotational direction
(see figure A)
Do not use the rotational direction
switch 3 when the power tool is in
operation, as this may damage it.
Clockwise rotation:
To screw in
screws, slide the rotational direction
switch
3
forwards.
Anti-clockwise rotation:
To loosen or
unscrew screws, slide the rotational
direction switch
3
back.
OBJ_BUCH-3206-001.book Page 19 Monday, June 12, 2017
