24
▶ Service
P r e v e n t i v e m a i n -
tenance performed
b y u n a u t h o r i z e d p e r s o n n e l m a y
result in misplacing of internal wires
and components which could cause
serious hazard.
We recommend that
all tool service be performed by a
B o s c h F a c t o r y S e r v i c e C e n t e r o r
Autho rized Bosch Service Station.
▼ TOOL LUBRICATION
Your Bosch tool has been properly
lubricated and is ready to use. It is
recommended that tools with gears
b e r e g r e a s e d w i t h a s p e c i a l g e a r
lubricant at every brush change.
▼ CARBON BRUSHES
The brushes and commutator in your
tool have been engineered for many
h o u r s o f d e p e n d a b l e s e r v i c e . T o
maintain peak efficiency of the motor,
w e r e c o m m e n d e v e r y t w o t o s i x
months the brush es be examined.
O n l y g e n u i n e B o s c h r e p l a c e m e n t
brushes specially designed for your
tool should be used.
▼ BEARINGS
Bearings which become noisy (due to
heavy load or very abrasive material
cut ting) should be replaced at once to
avoid overheating or motor failure.
▶ Cleaning
To avoid accidents
always dis connect
t h e t o o l f r o m t h e p o w e r s u p p l y
before cleaning or performing any
m a i n t e n a n c e .
T h e t o o l m a y b e
c l e a n e d m o s t e f f e c t i v e l y w i t h
compressed dry air.
Always wear
safety gog gles when cleaning tools
with compressed air.
V e n t i l a t i o n o p e n i n g s a n d s w i t c h
levers must be kept clean and free of
foreign matter. Do not at tempt to
clean by inserting pointed objects
through openings.
C e r t a i n c l e a n i n g
agents and sol vents
damage plastic parts.
Some of these
are: gasoline, carbon tetrachlo ride,
c h l o r i n a t e d
c l e a n i n g
s o l v e n t s ,
ammonia and house hold detergents
that contain ammonia.
Maintenance
Operating Instructions
▼ CREATING A SEAM
1.
To create a precision seam, make
sure he guiding piece of laminate
has a clean, straight edge, because
it will serve as the guide for the
underscribe attachment.
2.
Contact cement should be applied
to the substrate core material and
the guiding piece of laminate up to
1” from its guiding edge.
2610052572_GKF125CE 9/18/18 12:11 PM Page 24