11
N e v e r u s e t h e d u s t e x t r a c t i o n
attachment without a filter.
If the dust
extraction attachment is used without a
filter, larger particles of drilling dust can
b e f l u n g t o w a r d s t h e u s e r a n d t h e
power tool can be damaged.
O n l y u s e a n u n d a m a g e d f i l t e r ( n o
cracks, small holes, etc.). Replace a
damaged filter immediately.
Never carry the power tool by the dust
extraction attachment.
Note:
The guide
4
is spring-loaded. The
g u i d e c a n s p r i n g f o r w a r d w h e n t h e
button
6
for drill bit length adjustment
is pressed (Fig. 1).
▶ Turning On and Off
To turn on the dust collector, press the
On/Off pushbutton switch
8
.
To turn off the dust collector, press the
O n / O f f p u s h b u t t o n s w i t c h
8
a g a i n
(Fig. 1).
▼ BATTERy CHARGE LEVEL
INDICATOR
After turning the unit on, the five green
LEDs
9
will indicate the charging level of
the battery
15
(Fig. 1).
▶ Inserting/Removing Drill Bits
(Fig. 4)
-
Press and hold the button
6
and pull the
guide
4
all the way outward.
-
Release the button
6
.
-
Slide the tip of the drill bit through the
intake dust ring
3
from behind (A) and
then fit the bit into the chuck according to
the instructions of your power tool (B).
-
Before removing the drill bit, press the
button
6
again and pull the guide
4
all the
way outward.
▶ Adjusting the Guide Length
(Fig. 5)
To ensure that dust is extracted cleanly
and the depth stop is set correctly, the
guide
4
must be adjusted so that the tip
of the drill bit is flush at the front with
the intake dust ring
3
.
-
Press and hold (
A
) the button
6
and
move (
B
) the guide
4
until the tip of
the drill bit is flush with the
“crosshair” of the intake dust ring
3
.
-
Release the button
6
.
N o t e :
T o s t o r e t h e d u s t e x t r a c t i o n
attachment, press the button
6
and pull
the guide
4
all the way outward. This
relieves strain on the guide’s spring,
w h i c h i n c r e a s e s t h e l i f e t i m e o f t h e
spring.
B
6
4
3
A
Fig. 4
3
3
3
6
4
3
B
A
Fig. 5
Operating instructions
2610051575.qxp_GDE18V-16D 8/29/18 2:30 PM Page 11
