24
| English
1 609 929 U62 | (8/24/10)
Bosch Power Tools
Assembly
f
Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.
Delivery Scope
Carefully remove all parts included in the deliv-
ery from their packaging.
Remove all packaging material from the machine
and the accessories provided.
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Cut-off grinder with mounted cutting disc
– Ring spanner
14
Note:
Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Stationary or Flexible Mounting
f
To ensure safe handling, the machine must
be mounted on a level and stable surface
(e. g., workbench) prior to using.
Mounting to a Working Surface (see figure A)
– Fasten the power tool with suitable screw
fasteners to the working surface. The mount-
ing holes
11
serve for this purpose.
Flexible Mounting (not recommended!)
In the exceptional case that it should not be pos-
sible to firmly bench-mount the power tool, you
can provisionally place the legs of base plate
12
on a suitable surface (e. g. a workbench, level
floor, etc.) without bolting the machine down.
Changing the Tool (see figures B1
–
B2)
f
Before any work on the machine itself, pull
the mains plug.
f
Actuate the spindle lock 5 only when the
tool spindle 21 is stopped.
Otherwise, the
machine can become damaged.
f
Do not touch the cutting disc after working
before it has cooled.
The cutting disc be-
comes very hot while working.
Use only cutting discs that have an equal or
higher maximal allowable speed than the no-
load speed of your power tool.
Use only cutting discs that correspond to the
characteristic data given in these operating in-
structions and are checked according to
EN 12413 and marked appropriately.
Place unused cutting discs in an enclosed con-
tainer or in the original packaging. Store cutting
discs lying flat.
Removing the Cutting Disc
– Bring the power tool into the working posi-
tion. (see “Releasing the Machine (Working
Position)”, page 25)
– Swing back the retracting blade guard
4
to
the stop.
– Turn hexagon bolt
24
with the provided ring
spanner
14
(15 mm) and at the same time
press the spindle lock
5
until it engages.
– Hold the spindle lock pressed and unscrew
the hexagon bolt
24
.
– Remove the washer
23
and the clamping
flange
22
.
– Remove the cutting disc
6
.
Installing the Cutting Disc
If required, clean all parts to be mounted prior
to assembly.
– Mount the new cutting disc onto the tool
spindle
21
in such a manner that its lable fac-
es away from the tool arm.
– Mount the clamping flange
22
, the washer
23
and the hexagon bolt
24
.
Press spindle lock
5
until it engages and
tighten hexagon bolt
24
with the provided
ring spanner
14
. (Tightening torque approx.
18–20 Nm)
OBJ_BUCH-1063-002.book Page 24 Tuesday, August 24, 2010 10:05 AM