Voice Sounder Indoor
Installation | en
11
Bosch Sicherheitssysteme GmbH
2020.02 | 6 | F.01U.273.478
Notice!
The 28 pregrogrammed signals can be selected in the
FSP-5000-RPS programming software.
With the Configuration Software individual signals can be
programmed using the provided tone types and the provided
voice messages.
Notice!
Devices with LSN improved setting and same signal can be
synchronized within one alarm group. Devices with different
LSN settings (classic and improved) cannot be synchronized
within one alarm group. In one LSN loop, LSN improved and
LSN classic alarm groups can be mixed.
Not synchronized devices may only be installed in positions
where they do not interact acoustically with other devices.
Notice!
Only if the sounder volume is set to the maximum level, the
certified signals comply with EN54-3.
Certified sound measurements are listed in the document
Bulletin_Sound_Pressure_Level_EN54-3.pdf (F.01U.283.373),
which can be obtained from the manufacturer.
2
Installation
See
1.
Open the Sounder Indoor using the tool supplied (1). Press
the point of the tool into the openings provided for it on
the housing.
2.
Drill the required holes (2) on the rear side of the housing
and feed the cable into the housing.
3.
Fit the rear of the housing on a level, dry surface using the
pre-punched and/or any existing bore holes (3) and a
minimum of two screws.
4.
Wire up the sounder using the terminal block.
Summary of Contents for FNM-420V-A-RD
Page 2: ......
Page 46: ...46 Teknik veriler Voice Sounder Indoor 2020 02 6 F 01U 273 478 Bosch Sicherheitssysteme GmbH ...
Page 47: ......
