3
INITIAL PREPARATIONS
Determine the operating voltage at the
installation site. The camera‘s Voltage
Regulator Board accepts 12V dc or
24V ac input.
See
Section 2, Input Power Connections.
Determine the optimum location for the
camera.
Section 3, Mounting-Camera Base.
All cameras have been tested prior to
shipment. After the wiring has been
reconnected, it is advisable to check the
camera’s operation before installation.
ESD protection
– Cameras and circuit boards
are sensitive electronic components. It is
recommended to wear a ground strap to
ground any static charge. (Alternative: touch a
grounded metal plate for at least a minute
before proceeding with any disassembly)
GUIDELINES
The installation of the
EX49
camera is explained in
Sections 1 to 5 listed below. It is important that these
steps are followed in sequence
1.
Dome Removal
2. Input Power Connections
3. Mounting – Camera Base
4. Lens Directional and Focus Adjustments
5.
Camera Re-Assembly
Summary of Contents for EX49
