10
The mounting holes are configured for a single-gang
electrical box or a round ceiling electrical box. The
camera base can also be mounted to any flat
surface. See the template on page 29.
It would be advantageous if the power and video
wires from the remote source could be routed
into the electrical box at this time.
Step 3.1 - Feed the camera’s power and video
cables through the foam gasket
hole.
Step 3.2 - Connect these cables to the power
and video cables that are routed
from their remote location into the
electrical box.
Step 3.3 - Mount the camera housing to the
electrical box. (Screws are not
supplied).
Refer
to
Figure 3-1-1, Figure 3-1-2
and
Figure 3-1-3
on page 11, 12
and 13.
Summary of Contents for EX49
