24
No Video
(cont’d.)
__________
Poor
Picture
Snowy
Image
2. Video
Connections
________________
Poor Video Signal
Determine if wiring
polarity at “Video
Connector” terminal
block is correct.
Check the cable and
BNC connector.
If still no video,
connect the camera
directly to monitor.
Check the video
signal. If okay, the
problem is with the
interconnections. If
still no video, contact
BOSCH Service
Center. See rear
page of this manual
for contact
information
_________________
Ensure the video
cable is correctly
matched and
terminated with 75
ohms at each end.
Make sure the video
cables are similar
types.
Summary of Contents for EX40N
