DS484Q/DS486Q
|
Installation Instructions | 2.0
Installation
6
Bosch Security Systems, Inc. | 7/05 | 4998138530F
2.2 Mounting
Mount the DS484Q and DS486Q in one of two ways:
•
Pole mounted
•
Wall mounted
2.2.1 Pole
Mounting
1.
Choose an appropriate mounting location for
the system. Install poles with a clear line-of-
sight between the transmitter and the receiver.
2.
Loosen the transmitter’s cover mounting screw
and remove the cover. Refer to
Items 3
and
17
in
Figure 1
on page 2
.
3.
Loosen the two mounting screws and remove
the chassis by sliding it down against the base
Refer to Refer to
Items 1
and
9
in
Figure 1
on
page 2.
Single Unit Pole Mounting
1.
Use the short clamping screws to attach the
mounting plates to the chassis. Refer to
Figure 6
.
2.
If the pole diameter is between 3.8 cm and 4 cm
(1.5 in. and 1.6 in.), use the shorter flange
(1.0 cm [0.4 in.]) of the mounting plate.
If the pole diameter is between 4 cm (1.6 in.) and
4.3 cm (1.7 in.), use the longer flange (1.5 cm
[0.6 in.]) of the mounting plate. This ensures that
the end of the screw does not contact the pole.
Figure 6:
Using Mounting Plates
1
3
2
1 - Mounting plate
2 - Chassis
3 - Short clamping screws
3.
Use the U-clamps and the long clamping screws to
attach the chassis firmly. Refer to
Figure 7.
Make
sure the transmitter is mounted in direct line-of-
sight of the receiver.
Figure 7:
Using U-clamps
2
1
1 - U-clamp
2 - Long clamping screws
4.
Insert the wiring through the chassis wire entrance,
leaving enough wire to access the transmitter’s
terminal block. Refer to
Items 6
and
7
in
Figure 1
on
page 2.
5.
Slide the transmitter onto the chassis. Tighten the
base mounting screws. Refer to
Figure 1
on page 2.
6.
Repeat the mounting process for the receiver.
Make sure to mount the receiver in direct line-of-
sight of the transmitter.
