. . .
Change
D
R
D
R
D
R
Change
Change
D
Operation at the Inverter
3–4
1070 066 028-101 (01.05) GB
3.4
Changing parameters
Basic display
Computer booted, temperature display, status display
(see Section 2.1)
Do not activate enable signal!
Depress “D” key.
Select display functions
Status displays A or
parameter list PL1...PL8.
Only the list predefined on terminal block X06.5–7 may
be selected.
Depress “D” key.
Select parameter
Select the desired parameter from the P00 ... P49 area
using the ’
"
’ or ’
#
’ keys.
Depress “D” key.
Save new value entries with the ’D’ key when returning
(all unassigned decimal points of the display are flash-
ing). Then return with the ”Return” keys.
.
Before values can be changed, the write protection
must be disabled by pressing the boot key, cf.
page 5–1.
Change value
The display shows the value set in the factory or another
value that has been input.
The parameter is changed to the desired values using
the ’
"
’ or ’
#
’ keys.
.
The display flashes when the admissible value
range is left.
