Bosch DIP-2040-00N, Quick Installation Manual, Page: 15 / 40

System setup - first steps
The following installation directive provides information on
Installation and Configuration.
DIVAR IP systems are based on Windows Storage
Server 2008 R2 operating system.
This chapter is valid for DIVAR IP models that come with pre-
installed hard drives. Empty units start into the DOM recovery
menu on first start. The recovery process is described in the
installation manual.
See also:
–
Additional documentation and client software, page 27
Introduction
DIVAR IP systems are shipped with a pre-installed Configuration
Wizard from factory.
Setup instruction
All DIVAR IP systems are preconfigured with a default IP address
and with default iSCSI settings.
–
IP Address: 192.168.0.200
– Subnet mask: 255.255.255.0
Observe the following:
–
DIVAR IP needs to have an active network link during
installation. Make sure that the network switch you are
connecting to is powered on.
– The default IP address must not be occupied by any other
device in the network.
– Determine whether the initial installation is on a DHCP
network. If not then you must assign valid IP addresses to
the video devices. Consult the local IT administrator to
obtain a valid IP address range to be used with DIVAR IP
and associated devices.
– The default iSCSI settings are optimized for use with VRM.
3
3.1
3.2
DIVAR IP 2000 System setup - first steps | en 15
Bosch Sicherheitssysteme GmbH 2013.09 | V4 | DOC