5
DINION imager 9000 HD
Safety | en
4. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
power where they exit from the apparatus.
5. Use only attachments/accessories specified by the
manufacturer.
6. Refer all servicing to qualified service personnel. Servicing
is required when the apparatus has been damaged in a
way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus,
does not operate normally, or has dropped. When
servicing, power shall be disconnected.
1.3
Important notices
Accessories -
Do not place this unit on an
unstable stand, tripod, bracket, or mount. The
unit may fall, causing serious injury and/or
serious damage to the unit. Use only with the
cart, stand, tripod, bracket, or table specified by
the manufacturer. When a cart is used, use
caution and care when moving the cart/
apparatus combination to avoid injury from tip
over. Quick stops, excessive force, or uneven
surfaces may cause the cart/unit combination to
overturn. Mount the unit per the manufacturer's
instructions.
All-pole power switch -
Incorporate an all-pole power switch,
with a contact separation of at least 3 mm in each pole, into the
electrical installation of the building. If it is needed to open the
housing for servicing and/or other activities, use this all-pole
switch as the main disconnect device for switching off the
voltage to the unit.
Camera signal -
Protect the cable with a primary protector if
the camera signal is beyond 140 feet, in accordance with
NEC800 (CEC Section 60)
.
Bosch Security Systems
Installation manual
AM18-Q0663 | 1.0 | 2013.09
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
