Filters and maintenance
Fitting grease filters:
1.
Clamp in the filter mats with the wire
grid.
2.
Position the filter screen against the
housing and push upwards. Push in the
lower edge over the lugs and lower the
grid into place.
Check that the filter screen is securely
located behind the retaining brackets on
both sides.
1.
2.
Removal the grease filter:
1.
Open door as far as it will go.
2. Push the filter screen up slightly, lift it
towards you over the brackets and take
it out downwards..
3
. Remove the wire grid.
4. Fleece grease filter
Remove saturated filter mat, clean the
filter grid and insert new filter mat.
Metal grease filter
Remove saturated
filter mats, clean
mats and grid.
Refit the cleaned
filter mats, making
sure that there is no
gap in the middle.
7
9000.022 729.qxd 12.10.2006 9:35 Uhr Seite 7