2 609 140 572 | (8.9.08)
Bosch Power Tools
12
|
HOLD (Memory)
The hold memory is a single-value
memory that is useful for several
purposes:
– For storing a specific angle value
will be used repeatedly in com-
pound cut calculations, such as
the common 38° crown molding
spring angle.
– For storing an angle measured in
a confined situation …
y
when the display cannot be
seen when the measurement
is taken and
y
when it is necessary to fold
the leg to move the tool so
that the display can be seen.
(For example, when measur-
ing the angle of eaves from an
attic.)
Procedure
To store an angle in the HOLD
memory,
– Press the RECALL/HOLD button
5
for more than 1 second.
– The display and HOLD indicator
g
blink twice of to confirm the suc-
cessful storage of the angle.
To recall the stored angle, simply
press the RECALL/HOLD button
5
for less than 1 second. The recalled
angle then flashes in the display.
Notes:
– The tool maintains the stored
angle even after the tool is shut-
off manually or automatically.
– However, if the battery power is
exhausted or when the batteries
are removed, the stored angle
will be lost and need to be re-
stored after new batteries are in-
stalled.
– If the HOLD button is pressed
for more than 1 second when
0.0° is the displayed angle, any
stored angle is deleted.
daf220_bu_2609140572_003.fm Seite 12 Montag, 8. September 2008 2:22 14
