Bosch CTL836E.6, Instruction Manual

Page: 42 / 134

38
en Initial use
C
start/stop
Press
C
for either beverage preparation
or to launch a service programme�
Press
C
again while the drink is being
prepared to prematurely halt dispensing�
There are four menu fields in the control
panel which can be activated by touching�
The active menu field lights up red.
m
m
lights up as soon as the
appliance is in operation� Drinks can be
selected and dispensed or settings for the
drinks can be changed�
B
MyCoffee
Touch
B
to open the selection of
“ Personalised beverage preparation”�
Personal settings for coffee drinks can
be saved and called up (see the section
“ Personalised drinks”)�
A
Menu
Touch
A
to call up the menu� Settings
can be made, information called up or the
appliance connected with “Home Connect”
(see section “Menu”)�
E
Service
Touch
E
to open the selection of service
programmes. Run the desired programme
as described in the section “Service
programmes”�
F
Press
A
,
E
or
B
again to exit
the respective menu�
Control ring
Turn the control ring to navigate in the
display or to change parameters�
Information display
The round display shows the drink selected,
the settings or information�
Touch display (left and right)
Depending on the setting, different fields
are shon in both the touch displays. A field
is activated when touched either to enter
settings or change values�
Initial use
General
Fill the appropriate container using only
pure,
cold
, uncarbonated water and solely
roasted beans. Do not use coffee beans
that have been glazed, caramelised or
treated with other additives containing
sugar, since they will block the brewing unit�
A
Before the appliance can be switched
on and used, it must be assembled
and connected according to the
enclosed assembly instructions�
Setting up the appliance
■ Remove any protective plastic film.
F
Important: Only use the appliance
in a frost-free room� If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before initial use�
■ Take hold of the appliance door by the
recessed grip and open�
■ Remove the water tank, rinse it and fill it
with fresh water up to the “max�” mark�
■ Replace the water tank and click into
place�
■ Remove the bean container, fill with
coffee beans and replace.
■ Set the mains switch to
I
and close
the appliance door�
The appliance heats up and is rinsed�
The control panel is activated�
“Language”
appears�
■ Turn the control ring with your finger to
select the desired language and touch the
[ Water hardness ]
field.