▶ Depth Adjustment
Y o u r s a w i s e q u i p p e d w i t h a d e p t h
detent system that will stop the foot at
2x, 3/4", 1/2", and 1/4" standard lumber
depths.
Disconnect plug from power source.
L o o s e n t h e d e p t h a d j u s t m e n t l e v e r
located in the housing of saw. Hold the
foot down with one hand and raise or
lower saw by the handle.
T i g h t e n l e v e r a t t h e d e p t h s e t t i n g
desired. Check desired depth (Fig. 6).
Your saw also features a adjustable
depth adjustment lever for consistent
locking. To adjust, simply pull outward
o n l e v e r a n d r e p o s i t i o n t o d e s i r e d
position (Fig. 6).
Not more than one tooth length of the
blade should extend below the material
t o b e c u t , f o r m i n i m u m s p l i n t e r i n g
(Fig. 7).
▶ 90° Cutting Angle Check
Disconnect plug from power source. Set
foot to maximum depth of cut setting.
Loosen bevel adjustment lever, set to 0°
on quadrant, retighten lever and check
for 90° angle between the blade and
bottom plane of foot with a square (Fig.
8). Make adjustments by turning the
small alignment screw from bottom side
of foot, if necessary.
▶ Bevel Adjustment
Y o u r s a w i s e q u i p p e d w i t h a b e v e l
detent system that will stop the foot at
22.5°, and 45° angles.
Disconnect plug from power source. The
f o o t c a n b e a d j u s t e d u p t o 5 6 ° b y
loosening the bevel adjustment lever at
the front of the saw. Align to desired
a n g l e o n c a l i b r a t e d q u a d r a n t . T h e n
tighten bevel adjustment lever (Fig. 9).
Your saw also features a adjustable
bevel adjustment lever for consistent
locking. To adjust, simply pull outward
o n l e v e r a n d r e p o s i t i o n t o d e s i r e d
position (Fig. 1).
Because of the increased amount of
b l a d e e n g a g e m e n t i n t h e w o r k a n d
decreased stability of the foot, blade
binding may occur. Keep the saw steady
and the foot firmly on the workpiece.
-12-
Operating Instructions
Fig. 7
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR
MINIMUM SPLINTERING
CALIBRATED
DEPTH BRACKET
ADJUSTABLE
DEPTH LEVER
Fig. 6
QUADRANT
BEVEL
ADJUSTMENT
LEVER
Fig. 9
Fig. 8
90°
BLADE
BEVEL
ADJUSTMENT
LEVER
FOOT
ALIGNMENT
SCREW
FOOT
1
2
2610051973.qxp_CS10 7/26/19 12:35 PM Page 12
