Connect S2 | Solar Frame
| User Guide
© Robert Bosch Manufacturing Solutions GmbH
Bosch Connected Industry
23 |
39
Mounting with Solar Frame, screwed
INFO
Use screws with a diameter of 5 mm for mounting. The length of the screws must be selected
according to the thickness of the support plate.
Use stainless steel (V2A, V4A) screws suitable for the application and sufficiently strong.
Mounting parameters:
Length of the screws
Thickness of carrier plate + 13 mm to 18 mm
Tightening torque of the flange nuts M5
hand-tight
Mounting steps:
1.
Mark holes with the help of the Solar Frame
2.
Drill holes
3.
Activate gateway
4.
Connect Solar Frame connector to gateway
5.
Insert the gateway into the Solar Frame from below
6.
Screws M5 with the length: material thi 13 mm to 18 mm
7.
Mount the supplied washers
8.
Screw the Solar Frame hand-tight with the four flange nuts supplied
9.
Check that all four mounting points hold the Solar Frame
10.
Close the screw holes with the supplied plugs
Exploded view
Rear view
Side view
