Connect S2 | Solar Frame
| User Guide
© Robert Bosch Manufacturing Solutions GmbH
Bosch Connected Industry
14 |
39
6
Activation and coupling of the Connect S2
Activation
To activate a new Connect Gateway, hold an active NFC scanning device against the housing. The gateway starts
automatically and connects to the Bosch server to download firmware and perform configuration. The status LED flashes red
for 1 second and green for 1 second when the device is powered up via NFC.
After activation (red/green flashing of the LED) or if the Connect S2 is connected to the charger when the battery is empty,
the gateway needs a few minutes to start up. The device status is only signalled by LED after the startup.
Coupling
Use the mobile apps provided by Bosch Connected Industry to link (couple) the Connect Gateway to your asset. The apps
can read the unique ID, which is encoded in a QR code on the gateway, and transmit this information to the Bosch server
along with your asset ID.
NFC antenna
Status LED
Connector for power supply