15
BASE AND TOE PANEL (Continued)
Method B - Plastic Base Access Panel and Toe Panel
Installation (select models)
1
Place the Plastic Base Access Panel under and up
the front bottom panel of the dishwasher, as shown in
Figure 36a
.
2
Insert the Plastic Base Access Panel screws into the
Plastic Base Access Panel, as shown in
Figure 36b
.
Tighten the Plastic Base Access Panel Screws.
3
Place the Cotton Insulation Strip under the unit,
between the bottom of the Plastic Base Access Panel
and the floor, as shown in
Figure 36c
.
4
Attach the Metal Toe Panel to the Plastic Base
Access Panel using the Toe Panel Screws included in
the Toe Panel Installation Kit. See
Figure 36d
.
NOTE:
You will not use the normal Toe Panel Screws
included in the Dishwasher Installation Kit on these
models.
Figure 36
a
b
d
c
Base and Toe Panel/ Final Instructions
In some conditions, Hydrogen gas can form in
a hot water system that has not been used for
weeks. Hydrogen gas is explosive. Before filling
a dishwasher from a system that has been off
for weeks, run the water from a nearby faucet in
a well ventilated area until there is no sound or
evidence of gas.
FINAL INSTRUCTIONS
1
Energize the dishwasher power supply circuit.
2
Consult the Dishwasher Use and Care Manual, and
run the dishwasher through one complete cycle. If
the dishwasher does not operate properly, refer to
the Self-Help section of the Use and Care Manual. If
the dishwasher still does not operate properly, refer
to the Customer Service Section of the Use and Care
Manual.
WARNING
