16
/24
BODAS controller RC/3x and RC/4x
| Installation
Bosch Rexroth AG, RE 95240-01-B/2021-01-12
7.3 Mounting the control unit
• The BODAS controller must be mounted in the vehicle so that it does not bounce
against other vehicle parts and additional mounting elements of the control unit.
• This tightening torque applies for fitting without washer. The equivalent tightening
torque must be calculated when using washers. For recommended screw sizes and
tightening torques, refer to the following table.
Table 7: Screw size and tightening torques
Designation
Recommended screw size
Maximum tightening torques
RC4-5, series 30
M4, head diameter > 7 mm
3.0 Nm (with washer),
2.5 Nm (without washer)
RC12-10, series 30
M6
10.0 Nm (without washer)
RC20-10, series 30
RC28-14, series 30
RC10-10, series 31
RC5-6, series 40
RC18-12, series 40
RC18-12E, series 40
RC27-18, series 40
RC27-18E, series 40
• Rexroth's consent is required if mounting is different from above.
• The minimum distance between the underside and the mounting surface of the
vehicle is 1 mm.
• For the RC4-5-30 control unit, the following applies: The distance between the
underside and the mounting surface should be less than 10 mm. If the control
unit is not mounted with a holder, it should be mounted with four distance bolts
guaranteeing this distance and preventing bending of the base plate in the area of
the screw holes.
• The evenness of the mounting surface between points a, b, c and d
(drawing see data sheets 95204, 95205, 95206, 95207 and 95208) is 0.5.
• The wiring harness should be fixated in the area in which the control unit is
installed (spacing < 150 mm) in such a way that the in-phase excitation with the
control unit occurs (e.g. at the control unit tightening point).
• The wiring harness should be mounted in such a way that there is enough space for
the mating connector to be unplugged without having too much force acting on the
mating connector.
• If the mounting surface is not sufficiently even, place flexible compensating
elements between the mounting points of the BODAS controller and the mounting
surface.
