Bosch Benchmark SHV8PT53UC, Operating Instructions Manual

Page: 19 / 64

18
Interrupt a cycle
1 Press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the [On/Off] button again.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Press the [On/Off] button. Select a cycle.
2 Press the [Delay] button until the displayed time corresponds with
your requirements and press [Start] to activate delay start.
h:01
= 1 hour delay
h:24
= 24 hour delay
To cancel delay start:
1
Press the [Delay] button until “ h:00 ” is indicated on the digital display.
2 Press [Start] to save setting.
Cycle Completion Signal
1 Open the door and press the [On/Off] button.
2 Hold down the “ A ” button (see page 17) and press [Start] until the
display indicates “ d:00 ”. Release both buttons.
3 Press the “ A ” button until the display shows “ b:02 ”.
4 Press the “ C ” button to increase or decrease the tone “ b:00 ” = OFF and
“ b:03 ” = LOUDEST and press [Start] to save setting and close the door.
Intensive Drying
The final rinse uses a higher temperature which improves the drying
results. The running time may increase slightly.
To turn intensive drying on:
1
Press the [On/Off] button.
2 Hold down the “ A ” button and press [Start] until the display indi-
cates “ d:00 ”. Release both buttons
3 Press the “ A ” button until the display shows “ d:00 ”.
4 Press the “ C ” button to turn intensive drying on or off. “ d:01 ” = ON
and “ d:00 ” = OFF and press [Start] to save setting.
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash
cycle ends. Auto Power Off can be adjusted from P:00 to P:02.
To change the factory setting (P:01):
1
Press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indi-
cates
“d:00”
. Release both buttons.
3 Press the “A” button until the display indicates “P:01” .
4 Press the “C” button until the display corresponds with your require-
ments.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
5
Press [Start] to save the setting
.